Specs
Feature
Hourly work efficiency |
40 acres |
High-precision radar |
√ Spherical Omnidirectional Radar System |
Remote control planning accuracy |
√ (RTK/GNSS) |
Pipe air exhaust |
√ One button Air Discharge |
3D operation planning by the AI smart engine |
√ |
High-precision flowmeter |
√ (Dual-channel electromagnetic flowmeter with an error of ±2%) |
Level gauge |
Continuous level gauge (with real-time pesticide load detection and intelligent supply-point prediction) |
Maximum spray flow |
- 7.2L/min (with the XR11001 nozzle)
- 8L/min (with the XR110015 optional nozzle)
|
Pesticide tank installation method |
Fixed pesticide tank |
Battery installation method |
Removable batteries |
Single remote control for multiple drones |
√ (Single remote control for up to three drones) |
D-RTK technology |
√ |
Top-view radar module |
√ |
Flight laser function |
√ |
Intelligent endurance/return function |
√ |
Intelligent supply-point prediction |
√ |
Front-view FPV |
√ |
Rear-view FPV |
√ |
Coordinated turning function |
√ |
Branch targeting technology |
√ |
Drone parameters
Total weight (without batteries) |
26.4 kg |
Maximum take-off weight |
78 kg (near sea level) |
Maximum thrust-to-weight ratio |
1.70 @ takeoff weight of 66.5 kg |
Hovering precision (with good GNSS signal) |
With D-RTK enabled: ±10 cm (horizontal) and ±10 cm (vertical) With D-RTK disabled: ±0.6m (horizontal) and ±0.3m (vertical) (with the radar function enabled: ±0.1m) |
RTK and GNSS frequency bands |
- RTK: GPS L1/L2, GLONASS F1/F2, BeiDou B1/B2, and Galileo E1/E5
- GNSS: GPS L1, GLONASS F1, and Galileo E1
|
Maximum power consumption |
11,000 W |
Hovering power consumption |
10,000 W (@ takeoff weight of 66.5 kg) |
Hovering endurance |
- 20.5min (@29,000 mAh & takeoff weight of 36.5 kg)
- 7.8min (@29,000 mAh & takeoff weight of 66.5 kg)
|
Maximum pitch angle |
15° |
Maximum operating flight speed |
7 m/s |
Maximum level speed |
10 m/s (with good GNSS signal) |
Maximum tolerable wind speed |
6 m/s |
Maximum flight altitude |
4,500m *Reduce the pesticide load by 12% for each increase of 1,000 meters in altitude. |
Recommended operating ambient humidity |
< 93% |
Recommended operating ambient temperature |
0℃ to 45℃ |
Chassis parameters
Maximum rotor distance |
2,145 mm |
Dimensions |
- 2,858 mm × 2,685 mm × 790 mm (with arms and blades unfolded)
- 2,030 mm × 1,866 mm × 790 mm (with arms unfolded and blades folded)
- 1,170 mm × 670 mm × 857 mm (with arms folded)
|
Power system – Motor
Stator size |
100×18 mm |
KV value |
77 rpm/V |
Maximum pull |
18.7 kg/rotor |
Maximum power |
3,600 W/rotor |
Weight |
756 g |
Power system – Propellers
Diameter × pitch |
38×20 inch |
Weight (with a single blade) |
106 g |
Power system – ESC
Maximum operating current (continuous) |
60 A |
Maximum operating voltage |
60.9 V (14S LiPo) |
FPV cameras
View angle (FOV) |
Horizontal: 129°, vertical:82° |
Resolution |
1,280×720 15-30 fps |
FPV searchlights
Maximum light intensity |
13.2 lux @ 5-meter direct light |
Spraying system – Operation tank
Operation tank volume |
30L at full load |
Operating load |
30 kg at full load |
Spraying system – Nozzles
Nozzle model |
SX11001VS (standard) SX110015VS (optional) Fruit tree drones: TX-VK04 (optional) |
Nozzle quantity |
16 |
Maximum spray flow |
SX11001VS: 7.2L/min SX110015VS: 8L/min TX-VK4:3.6 L/min |
Atomized particle size |
SX11001VS : 130 – 250 μm SX110015VS : 170 – 265 μm TX-VK4: 110 – 135 μm (depending on the actual operating environment, spray flow, and other factors) |
Maximum effective spray width |
4-9 m (with 12 nozzles and a distance of 1.5 to 3 meters to crops) |
Spraying system – Water pump
Water pump model |
Plunger pump |
Operating voltage |
60 V |
Maximum flow |
4 L/min ×1 |
Spraying system – Flowmeter
Flow measurement range |
0.25 – 20 L/min |
Flow measurement error |
< ±2% |
Measurable liquid |
Conductivity > 50 μS/cm, typical liquids: Tap water or aqueous organic or inorganic pesticides |
Omnidirectional obstacle avoidance radar
Model |
RD2424R |
Operating frequency |
SRRC/NCC/FCC: 24.05 – 24.25 GHz MIC/KCC/CE: 24.05 – 24.25 GHz |
Operating power consumption |
12 W |
Equivalent isotropic radiated power (EIRP) |
SRRC: < 13 dBm; NCC/MIC/KCC/CE/FCC:< 20 dBm |
Height maintenance and terrain adaptation |
Height measurement range: 1-30 m Height-maintenance range: 1.5-15 m Maximum slope in mountain mode:35° |
Obstacle avoidance system |
Perceivable distance: 1.5-30 m View angle (FOV): Horizontal: 360°, vertical: ±15° Conditions of use: The relative altitude of the drone must be greater than 1.5 m and the speed less than 7 m/s Safety distance: 2.5 m (the distance between the tip of the propeller and the obstacle after the drone decelerates to a hover) Obstacle avoidance direction: Horizontally omnidirectional obstacle avoidance |
Water-resistance rating |
IP67 |
Top-view radar
Model |
RD2414U |
Operating frequency |
SRRC/NCC/FCC:24.05 – 24.25 GHz MIC/KCC/CE:24.05 – 24.25 GHz |
Overhead obstacle avoidance |
Perceivable distance: 1.5-10 m View angle (FOV): 80° Conditions of use: During take-off, landing, and climbing when the relative distance between the drone and the object above is greater than 1.5 m Safety distance: 2 m (the distance between the highest point on the top of the drone and the obstacle after the drone brakes and hovers stably) Obstacle avoidance direction: Above the drone |
Water-resistance rating |
IP67 |
Equivalent isotropic radiated power (EIRP) |
SRRC:< 13 dBm; NCC/MIC/KCC/CE/ FCC:< 20 dBm |
Operating power consumption |
4 W |
Battery
Model |
BAX501-29,000mAh-51.8V |
Weight |
Approximately 10.1 kg |
Discharge rate |
11.5C |
Water-resistance rating |
IP54 with board-level potting protection |
Capacity |
29,000 mAh |
Voltage |
51.8 V |
Remote control
Model |
RM500-ENT |
Operating frequency of the Ocusync Industry Edition |
2.4000 – 2.4835 GHz 5.725 – 5.850 GHz |
Effective signal range at the Ocusync Industry Edition operating frequency (without interference and blockage) |
SRRC: 5 km; MIC/KCC/CE: 4 km; FCC: 7 km (measured when the operating height of the drone is 2.5 m) |
EIRP of the operating frequency of the Ocusync Industry Edition |
2.4 GHz SRRC/CE/MIC/KCC: 18.5 dBm; FCC: 29.5 dBm; 5.8 GHz SRRC: 20.5 dBm; FCC: 28.5 dBm CE:12.5 dBm |
Wi-Fi protocols |
Wi-Fi Direct, Wireless Display, and 802.11a/g/n/ac Supports 2 × 2 MIMO Wi-Fi |
Wi-Fi operating frequency |
2.4000 – 2.4835 GHz 5.150 – 5.250 GHz 5.725 – 5.850 GHz |
Wi-Fi EIRP |
2.4 GHz SRRC/CE: 18.5 dBm; FCC/MIC/KCC:20.5 dBm; 5.2 GHz SRRC/FCC/CE/MIC: 14 dBm; KCC: 10 dBm; 5.8 GHz SRRC/FCC: 18 dBm; CE/KCC: 12 dBm; |
Bluetooth protocol |
Bluetooth 4.2 |
Bluetooth operating frequency |
2.4000 – 2.4835 GHz |
Bluetooth EIRP |
SRRC/MIC/FCC/CE/KCC:6.5 dBm |
Positioning |
GPS+GLONASS dual mode |
Display screen |
5.5-inch screen with a resolution of 1920×1080, brightness of 1,000 cd/m², and Android OS |
Operating memory (RAM) |
4GB LPDDR4 |
Storage space (ROM) |
A microSD card with 32 GB and extensible storage space for up to 128 GB, transfer speed rated as UHS-I Speed Grade 3 |
HDMI |
HDMI 1.4 |
Supported drones |
T30 and T10 agricultural drones |
Operating power consumption |
18 W |
Operating ambient temperature |
-10℃ to 40℃ |
Storage ambient temperature |
-30℃ to 60℃ (within 1 month) -30℃ to 45℃ (more than 1 month and less than 3 months) -30℃ to 35℃ (more than 3 months and less than 6 months) -30℃ to 25℃ (more than 6 months) (with built-in batteries charged to 40% to 60%) |
Charging ambient temperature |
5℃ to 40℃ |
Built-in batteries of the remote control
Built-in batteries |
18650 lithium-ion battery (5,000 mAh at 7.2V) |
Battery life |
2 hours |
Charging method |
Use a standard 12V/2A USB fast charger |
Charging time |
2.5 hours (use the 12V/2A USB fast charger when the remote control is powered off) |
Power supply current/voltage of the remote control USB-A port |
5 V / 1.5 A |
External smart battery of the remote control
Model |
WB37-4,920mAh-7.6V |
Battery type |
2S LiPo |
Capacity |
4,920 mAh |
Voltage |
7.6 V |
Capacity |
37.39 Wh |
Charging ambient temperature |
5℃ to 40℃ |
Battery life |
2 hours |
Charging assistant of the remote control external smart battery
Model |
WCH2 |
Input voltage |
17.3 – 26.2 V |
Output voltage and current |
8.7V and 6A |
Operating ambient temperature |
5℃ to 40℃ |
Power adapter of the external smart battery charging assistant
Model |
A14-057N1A |
Input voltage |
100 – 240V and 50/60 Hz |
Output voltage |
17.4 V |
Rated power |
57 W |
T30 Spreading System 3.0
Spreading system weight |
3.9kg |
Maximum opening area |
44.6 cm² |
Applicable materials |
Solid dry particles with a diameter of 0.5 to 5 mm |
Spreading tank volume |
40L |
Maximum load of the spreading tank |
35kg |
Water-resistance rating |
IP67 |
Input voltage |
Power: 60V Control:15V |
Maximum power |
60V@250W 15V@50W |
Recommended operating ambient temperature |
0℃ to 40℃ |
Dimensions |
560×435×320mm |
Maximum rotation speed |
1,300 RPM |
T30 smart charging manager
Dimensions |
300×280×230 mm |
Total weight |
11.5 kg |
Input voltage |
100-264 Vac |
Output voltage |
40-60 V |
Rated power |
7,200 |
Charging current |
120 A |
Charging time |
Fully charges a battery in 9 to 12 minutes |
Charging voltage accuracy |
+/-0.1 V |
Charging current accuracy |
+/-1 A |
Output channel quantity |
2 |
Protection functions |
Over-temperature, over-voltage, under-voltage, short-circuit, and fan stall protection |
Charging ambient temperature |
-20℃ to 45℃ |
Charging safety |
AC wire protection, power wire protection, and charge connector protection |
Notes
The terms HDMI, HDMI High-Definition Multimedia Interface, HDMI Trade dress and the HDMI Logos are trademarks or registered trademarks of HDMI Licensing Administrator, Inc.
Others
Guaranteed software updates until